How to disconnect clutch wires?

[m0use]

Guys, need your help. I'm installing the remote start on my manual LT.
Obviously it needs to pass the clutch to start the engine. The manual says I need to connect to one of wire that goes from clutch pedal.

The problem here: I can not figure out how to disconnect wires. I found out that this is ACDelco PT1649 connector but can't find any information on how to connect/disconnect it.

Any ideas/resources?

 

[m0use]

Finally after couple of hours of struggle I was able to unplug it.
Here is the details:

First you need to pull the white part up, on picture below it is already released, initially it's on the same level as black part of connector.

Next you push on area as pointed on picture and pull it off:

 

[Musichatesyouall]

Finally after couple of hours of struggle I was able to unplug it.
Here is the details:

First you need to pull the white part up, on picture below it is already released, initially it's on the same level as black part of connector.

Next you push on area as pointed on picture and pull it off:

Have you seen this thread?

http://www.sonicownersforum.com/for...155-sonic-vehicle-wiring-locations-sizes.html

 

[m0use]

Have you seen this thread?

http://www.sonicownersforum.com/for...155-sonic-vehicle-wiring-locations-sizes.html

Yes, it's helpful. But to actually do something with this wire/connector you need to at least unplug it because it's almost impossible to just reach it and definitely impossible to do something unless you release it, it's located so deep behind the steering wheel.
And I could not find how to actually take connector off (where to push to release the lock).

 

[$ub$onic]

If you had HPtuners you could disable that electronically. Just another option.

 

[Gavkat09]

Hard to disable??