Turbo inlet size

[MrSonic]

Question I'm hoping someone can answer.

What is the inlet size on the turbo? I know the intake pipe is 2.75"... I need to order a elbow for a custom intake.

Thank you,

 

[MrSonic]

All I need to know is the OD of the turbo inlet. From where the intake filter/MAF pipe meets the turbo.

 

[River_Rat]

With all due respect, why don't you go measure one?

 

[MrSonic]

Stuck in office for last minute testing of new application. I'm one of the developers and can't leave

BUT I found it on the turbo spec sheet ~2.25"

 

[Stew]

^ I will confirm it is indeed 2.25" OD.

If you are hard piping your stock air box you'll need a 2.75" to 2.25" 90 deg elbow to connect to the turbo inlet.

 

[MrSonic]

Does anyone know of any auto parts stores that sell that elbow?

 

[diazmjd]

^ I will confirm it is indeed 2.25" OD.

If you are hard piping your stock air box you'll need a 2.75" to 2.25" 90 deg elbow to connect to the turbo inlet.

Digging up from the grave here... I see several of you have gone 3" to 2.5". Just curious the general thoughts on fit here. I'm assuming that's outside diameter. Thanks!

 

[Bike Muff]

I did 3 to 2.75. I just re used the rubber ring seal that comes off the stock intake tube where it clamps to the turbo. Probably 2.25 would have been best but i jumped the gun...

However it seems to fit and work great. Hope that helps...

 

[Mr.turner85]

Anyone got a copy of this turbo spec sheet??


Sent from my iPhone using Tapatalk