Recent content by amazing wolverine

Looking to get a Mishimoto but I don't know the size

Made a,lip out of fiberglass still working on it this is what I have so far

M fab as a 4th mount and zzp as the other mount on driver side so my question is this can u stiffing you engine and transmission too much I not sure never done a hole lot of motor mount stuff side note the shaking on these mounts are not bad all but goes away after u get going

Why do the trunk sonics weight so much

This is as far as I have got so far what u think going to fiberglass it then put the sonic logo from trunk in the center

so many people tell how it's a waste to put money into my sonic but I love my car I think they have alot of room for hp no one looks at Hondas in that way they have 1.6l 1.8l what's your thoughts

I did a ram air with a mesh screen and a 3 inch flexible tube I picked this setup to reduce bug and road crap from getting in my engine bay wasn't hard all you need is a 75mm hole saw this ram fog light thing was 75mm in the back and the red part was 100mm fit wasn't all that hard I got the fog...

I upgraded my piping on my car it as a bead roll and t clamps but won't hold pushing 22psi any ideas

Got a 2014 chevy sonic 1.4 turbo with cold air intake upgrade intercooler 2.5 piping upgrade exhaust to 2.5 cat back tuned zzp lower and upper trans mount hopefully getting 42lb injectors next

Had my sonic for full exhaust upgrade the intercooler hard piped cold air intake oil catch can boost gauge mounting on the dash next tune trans then lowering

I put in a boost gauge and it goes crazy when it get around the 0