Recent content by Chappy86

Check your Intake hose. They can cause this and are known to tear. If not that, 02 sensor or PCV.

I have changed the passenger side motor mount. Vibration is still there. Guess I'll change the drivers side

Any takers?

I have a 13' auto with 84K miles. I have a vibration at idle, in drive or neutral, while driving. The vibration goes away a little when I put it in neutral. I have changed the passenger side mount motor but problem is still there. It idles just fine with no issues. Any thoughts

Thank you, pcv valve fixed the issue

Sounds like a vaccum leak coming from the fuel rail/ spark plug area. Almost inside of the valve cover. Any ideas? Is the pcv suppose to make a noise when shuttong off the car?

My 13 1.8L with 85,000 is rev'd once in park but mostly surges with low rpms. I have the dreaded P0171 code. Intake hose,filter is good. Cleaned the maf and 02 sensor. Spark plugs were changed at 45000ish miles. Any ideas?

Glad it worked out

Noise is gone, the bolt that hold the spring on to the shock came loose. Hopefully this thread helps someone in the future.

Ha, blinker fluid is good to go. Ill have to look into. Thank you.

Well, replaced the control arm. Still noise, any thoughts? Motor mounts?

I have a 2013 1.8l with 79k miles. When driving and going over bumbs, i hear a rubbing/clanking sound. I have changed the struts, and sway bar on the left and right side. Sound is coming from the ride. Any ideas?

Thank you, I'll give it a shot. Ball joints hard to replace?

Hey all, So I have clunking/rubbing issues in my front right wheel well. After reading multiple threads, I changed both front sway bar links. No luck. Think its the actual shock? If so, what brand should I replace them with? I don't race but don't want bottom of the barrel shocks. It's a 2013...

I had the same P0171. Ended up being a hole in my intake. Take it off and check thay rubber tubing. It has a bend to it that can hide a hole.