Search results

Hello all, I'm looking to safely remove the passenger side footwell airbag permanently. I believe a resistor will need to go in it's place, but I want to know what size and how that goes. It has to go so I have room for my front subwoofer enclosure and custom infinite baffle installed kickpanel...

Hello all, I'm looking to safely remove the passenger side footwell airbag permanently. I believe a resistor will need to go in it's place, but I want to know what size and how that goes. It has to go so I have room for my front subwoofer enclosure.

Slowly been chizzling away at other areas. Installed a few sheets of CLD on the inside of the cargo area, and treated the back left fender Liner and wheel well today. Used a small amount of fibermat 1", and approximately 4.5 sheets of of CLD. I'll tackle the other back fender tomorrow, due to...

2012 1.4L 6 speed manual transmission here. I have installed a ZZP downpipe/mid-pipe combo, deleted the secondary cat and the muffler, sound treated the rear heat shield that sits above the muffler, and temporarily removed the exhaust tunnel heat shield (will get reinstalled after sound...

Just posting to see if this is normal, I've been very keen on giving this new to me little Sonic a full tune up and the best quality parts I can. This morning before leaving for work I put in new spark plugs (gapped to 0.24 like instructed to in the coil pack box) and ZZP high voltage coil pack...

Sorry for resurrecting the dead. But i just did the back left door (inside of door card, and inner and outer door skins) of my 2012 hatchback. I used about 4.5x sheets of Resonix CLD, 2x sheets of Amazon basics CLD, 1x sheet of Megazorb from SecondSkin, and I think 4 or 5 Resonix Guardian. Oh...

I do like some green eggs and ham

But we could Alakazam

Or maybe we ham.

I guess we spam?

Looking to slap some enkei rpf1's and some meaty boi's on them. Probably going with 17" after reading a few pages of this thread! Thank you all that have contributed!

This is good to know, thank you for sharing this critical knowledge!

Might you have a picture or a link? Trying to avoid slapping on some cheap ebay crud.

Are the Husky's slippery like the weather tech units?