TrippinGearz
New member
As many of you know I have been obsessing over exhaust for quite a while. Now I have a new idea. As you know there is a cut out for the exhaust on the bottom of the bumper. I was thinking that with the correct angle of the pipes you could hide it and with the correct size mufflers this would be possible at the angle shown. It would take a good pipe bender(I know a few) and a lot of patience but im thinking it may be possible. But does anyone have measurements from rear axle to rear bumper? It may be a wild dream but I might try to make it happen.
Sent from my SCH-I535 using Tapatalk

Sent from my SCH-I535 using Tapatalk