Throttle Body Spacer 1.4L Sonic

[Dave@ddmworks]

This is a neat little piece we made up, it is a 3/4" throttle body spacer. It has 2 - 1/8" NPT holes in the top of it that allow you to install a barb fitting to run to a boost gauge, or use it for water/meth install, or for an intake air sensor. There are many possibilities, whatever goes into a 1/8" npt fitting can be installed. Pricing Starts at $42 and its just a couple bucks more if you want the fittings in there.

1.4L Ecotec Throttle Body Spacer

The piece is CNC machined from billet aluminum and then finished in a black anodize.

Options allow for plugs or barb fitting to be sent with the spacer so you do not even have to go find them.

Install is super quick and easy, just remove the bolts holding the throttle body in place, then install the spacer and using the new bolts supplied, tighten it all down.

1.4L Ecotec Throttle Body Spacer

 

[cndctrdj]

or meth

 

[sx sonic]

awesome!

Are there any gains in drivability or power with this? Or is it more for allowing additional guages or meth, etc?

 

[Maddmatts]

It won't give any gains. Just more options for other things that will.

 

[mitdr774]

How similar are the 1.8 and 1.4 throttle bodies as far as mounting and diameter?

 

[slitzell]

Time for a mech boost guage

 

[ripper806]

Awesome!

 

[Dave@ddmworks]

How similar are the 1.8 and 1.4 throttle bodies as far as mounting and diameter?

That is a good question, I will have to check and let you know.

 

[Dave@ddmworks]

How similar are the 1.8 and 1.4 throttle bodies as far as mounting and diameter?

I checked and the 1.8L has a completely different bolt pattern then the 1.4L, so this will not fit the 1.8L for sure.

 

[ol_blue]

Nitrous fogger?

 

[mitdr774]

I checked and the 1.8L has a completely different bolt pattern then the 1.4L, so this will not fit the 1.8L for sure.

Thank you.

 

[LTZracer51]

Has any used this to install a boost gauge and if so can you read vacuum from the throttle body or is it all positive pressure?