FS: 19mm Hubcentic Adapters 5x105

[Preloader]

I have no more use for these. I put approx 1,000 miles on them. They will get your stock wheels flush. No stud cutting necessary. Just bolt-on and flush.
$200 shipped.
PM me.

 

[rdss]

Pm sent!

 

[Eric Smit]

fastest sale on SOF ever?


-Eric Smit

 

[Preloader]

SOLD!!!!! To rdss. In 2 minutes flat. LMAO!!

 

[rdss]

Just saw it and I had been looking into getting a set myself. Perfect timing!!

 

[Eric Smit]

Good thing I have wheels on the way. ;P


-Eric Smit

 

[Preloader]

In hindsight I probably should have asked for more.opcorn:

 

[ThatTmoGuy]

Phuck me, I just got $200 my buddy owed me.

 

[Preloader]

I needed to make $200 to stop bumming out about my window....... Wanted to be fair and not give dibs....

Wasn't expecting them to go so quick.:banana:

 

[Eric Smit]

Time to upgrade to the full tune Tmo.

Well, good sale Preloader.


-Eric Smit

 

[ThatTmoGuy]

Eh, I dig intelliboost/smart octane and don't have enough to upgrade and get the cable :/

 

[Eric Smit]

you could just get the cable though, and then you're only $50 away.


-Eric Smit

 

[Preloader]

Eh, I dig intelliboost/smart octane and don't have enough to upgrade and get the cable :/

Not sure which direction you're heading with your build, but if you're chasing qtr mile times, your $200 would be better spent on a lot of other choices.
Jerry told me that the Forge BPV shows power gains over the stocker, because it holds boost better. Something to think about. I know it's on my list now.

 

[ThatTmoGuy]

I may just try to work a deal on some wheels. Gotta hold out JIC.

I'll start working on more power when the track open's back up, Then I can show proven results from each mod

 

[Eric Smit]

Not sure which direction you're heading with your build, but if you're chasing qtr mile times, your $200 would be better spent on a lot of other choices.
Jerry told me that the Forge BPV shows power gains over the stocker, because it holds boost better. Something to think about. I know it's on my list now.

If you push more boost. ;P


-Eric Smit

 

[Preloader]

Well..... He said the stock BPV was never designed to see 20's and that it bleeds boost ever so slightly under full WOT. The cobalt SS guys have seen boost hold 1-2 lbs higher with it.

Poke around here when you get a chance:
The Cobalt SS Network

 

[Eric Smit]

fair. I'll just eliminate it. ;P


-Eric Smit

 

[rdss]

In hindsight I probably should have asked for more.opcorn:

I guess I got lucky and picked them up before you changed your mind! Thanks again Preload! I look forward to getting them in and on the car!

 

[Preloader]

I did try them on my new wheels. It was too mexi-flush. Wheel poked over 1/2". Self-induced facepalm for not at least taking a picture:blankface:.
But it allowed me to get a measurement to find what is needed to get flush restored. 6-8mm spacers.

 

[Eric Smit]

I bet it looked awful. ;P


-Eric Smit