Cleaned up the hatch a bit.

[66roadie]

Badges? We don't need no stinkin' badges!



Now, about those bow ties...

 

[Coolbreezin]

Simple yet effective. Looks good.

 

[66roadie]

Fixed the bowtie.

 

[cuartz7o]

Looks super clean! I did the same

 

[r4tb3lly01]

What’d you use to debadge??


Sent from my iPhone using Tapatalk

 

[greg51]

debage

i used fishing line 20-30 lb test. just use sawing motion then glue remover. g

 

[TurtleOverlord]

Sent from my iPhone using Tapatalk

 

[66roadie]

What’d you use to debadge??

You can soften the glue with a heat gun then use fishing line or whatever to peel off the badges.

 

[Coolbreezin]

Looks good. Its my understanding that there are two plastic pins holding the emblem in place. Once you got past the adhesive, did you just pry the emblem off the paint? Is there a trick you can share with us or did you just pop it off?

 

[TurtleOverlord]

Once you got past the adhesive, did you just pry the emblem off the paint? Is there a trick you can share with us or did you just pop it off?

Same procedure as removing the other badges except with a lot more glue/tape on the back of it.
The pins dont hold it in or anything so they just slide right out.

I had the holes plugged with tiny screws and some silicone for a while.
I thought about wrapping the hatch, but this seemed easier.

 

[LetThatBassDrop]

You can soften the glue with a heat gun then use fishing line or whatever to peel off the badges.

What’d you use to remove the glue? Thanks!


Sent from my iPhone using Tapatalk

 

[66roadie]

3M General Purpose Adhesive Cleaner p/n 08987, followed by a little wax.

 

[TurtleOverlord]

I used goo gone, lighter fluid works too