Performance cams 1.4/1.8
- Thread starter zomby woof
- Start date
RealchicksDriveStick
New member
Any progress with Cam creation?? 
EyeluvSmegma
New member
Any progress with Cam creation??
Yeah, no. Probably not going to happen for multiple reasons already covered. It really doesn't take years for R&D even on a personal level to fab something like this. Granted I've never ground a cam, but I've taken flat sheet metal, a French wheel etc and made a set of peanut tanks for my Harley. I've custom made my own exhaust front to back, fuel cells, aluminum battery boxes and I'm currently a lead fabricator/welder in a well known restoration shop. Just take for Instance Racer X fab.... hey i have an idea and I'm serious.... 3 months later parts for sale. I was excited about it too, but now it's just annoying, endless rhetoric about how busy i am.
Flame me.... I'm on team DGAF
zomby woof
Member
Flame you? I wouldn't waste my time.
The development is done. I haven't been on here in a long time, and thought I would get notifications but I haven't. I have a few grinds but I'm not in a position to put anything in a motor at the moment. The only one I have is my Wife's Sonic and she likes it just fine the way it is. I have taken some measurements in a head, most of which have already been posted. My recommendation would be to first run something similar, if not exactly the same as the intake on the exhaust side. This motor needs more exhaust cam and that should keep it very mild on the street for daily driving but build boost quicker and allow it to make power at a higher RPM.
The reality is that there's really little to no interest, but if anybody is seriously interested you can contact me via PM and we can discuss it.
The development is done. I haven't been on here in a long time, and thought I would get notifications but I haven't. I have a few grinds but I'm not in a position to put anything in a motor at the moment. The only one I have is my Wife's Sonic and she likes it just fine the way it is. I have taken some measurements in a head, most of which have already been posted. My recommendation would be to first run something similar, if not exactly the same as the intake on the exhaust side. This motor needs more exhaust cam and that should keep it very mild on the street for daily driving but build boost quicker and allow it to make power at a higher RPM.
The reality is that there's really little to no interest, but if anybody is seriously interested you can contact me via PM and we can discuss it.
YouBeTailsIllBeSonic
Member
If I had the money......damn.
Sent from my SM-A520W using Tapatalk
Sent from my SM-A520W using Tapatalk
So, I’ve found that the cam phasers are the same part for both intake and exhaust. Is there a remote possibility that the intake cam will interchange with the exhaust cam for a straight swap. Obviously, a custom tune would be needed, but I just mean as far as the hardware.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk