Anacondas in production

[MPFab]

Still waiting on exhaust flex bellows, but in the meantime, I'm assembling the rear section with MPfab 100 cell cats.



The blue tape is protecting the logos.

 

[Larry]

Looks fantastic, what type of metal are these made from? SS T409?

 

[Preloader]

Can the second half be purchased separately?

 

[MPFab]

Looks fantastic, what type of metal are these made from? SS T409?

304 stainless

Can the second half be purchased separately?

Sure....but without the front part, I doubt it would do you any good.
These are specifically for the Anaconda. Doubtful it would bolt on to any other system.

 

[Preloader]

I can TIG in where I fit in. The primary portion won't line up with my Garrett, and I'll have a 3"DP that will. I'm just looking for a hlafway shortcut to get "3 over the steering rack. I can improv the rest.

 

[MPFab]

I can TIG in where I fit in. The primary portion won't line up with my Garrett, and I'll have a 3"DP that will. I'm just looking for a hlafway shortcut to get "3 over the steering rack. I can improv the rest.

I can probably do that. Let me get these finalized and see how many get sold before doing that. I've had a good bit of interest in these and I do not want have half of one, and have to scramble to get the other part built.

I have flex sections now and the front halves are ready for final welding.
I'll be out of town out after Weds so the next week will be tied up. Still hoping to have these ready by the beginning of Nov.

 

[Preloader]

I predict that these will replace the ZZP as the new must have downpipe.

If I didn't have a unique DP need for the turbo swap, I'd be ditching my ZZP for one of you Anacondas in a heartbeat.

 

[$ub$onic]

A second cat replacement with your race cats would be nice

 

[MPFab]

A second cat replacement with your race cats would be nice

Do you mean for people using other parts? Like if you already have ZZP stuff and want a bolt in cat section with this 3" cat?

 

[$ub$onic]

Do you mean for people using other parts? Like if you already have ZZP stuff and want a bolt in cat section with this 3" cat?

Basically. Here is my situation. I have a custom header/ mid pip from bnr and a magnaflow cat back. Nether of witch replace the stock second cat. But utilize the stock mounting locations for inlet and outlet. I am looking for a good replacement cat.