talldude67
New member
For u do-it-your selfs: remove rr panel with putty knife on both side of panel [not from where the locking hitch is].
Disconnect hot wire, secure with tie-wrap, remove 3 motor bolts, pull directly down, clean glass, install below parts for that clean look..
On the net find DANCO.NET, pt #89331, $2.67 for 3 piece item or BRASS CRAFT.com pt #1797, $2.97, bar code 10706.. + u need a insul rubber washer, dim: 1.9"dia. X 1.250" dia. X 140." thick.....
you will also need a rubber washer seal on the inside of the glass, with @ 7/16 dia X 1.250 dia. washer..tighten moderley. If you can't find this info on the net L@@K for bath / sink faucet cover...
Item comes with ss convex cvr...you can paint it color of your car or [me] painted it BBQ blk to match tire blk. panel install in reverse of take-off....zit for now....
Disconnect hot wire, secure with tie-wrap, remove 3 motor bolts, pull directly down, clean glass, install below parts for that clean look..
On the net find DANCO.NET, pt #89331, $2.67 for 3 piece item or BRASS CRAFT.com pt #1797, $2.97, bar code 10706.. + u need a insul rubber washer, dim: 1.9"dia. X 1.250" dia. X 140." thick.....
you will also need a rubber washer seal on the inside of the glass, with @ 7/16 dia X 1.250 dia. washer..tighten moderley. If you can't find this info on the net L@@K for bath / sink faucet cover...
Item comes with ss convex cvr...you can paint it color of your car or [me] painted it BBQ blk to match tire blk. panel install in reverse of take-off....zit for now....
Last edited:
