Adjusting Anzo Headlights

[Anthony]

Good afternoon. I recently installed my new pair of Anzo projector headlights. I purchased them through BNR.

After installing the lights and going for a test drive, I noticed that the lights are pretty much pointed at the ground. I need to adjust them to get more lateral coverage in front of the car.

I see the two screws on each light that need to be adjusted, however, I don't understand how I'm supposed to get a tool in there to adjust the lamps while they're on the car. I also don't see the point in adjusting them if they're not installed.

Does anyone have any tips for adjusting these lamps while they're on the car?

Thanks in advance.

 

[Anthony]

Any help here would be greatly appreciated.

 

[Tormach]

looking at the picture of the backside of the unit. Looks like you can use a ratcheting box wrench on the adjustment screws or a off-set philips screw driver or ratcheting driver set.

https://images-na.ssl-images-amazon.com/images/I/71HMpdIfeKL._SL1500_.jpg

https://www.homedepot.com/p/Husky-1-2-in-Offset-Screwdriver-74353/100038024

https://www.homedepot.com/p/Husky-M...PIPHorizontal2_rr-_-100038024-_-202934673-_-N

 

[wasteoffilm]

I just installed a set yesterday. The screw near the high beams is for the height, and is easily accessible while installed. It is a 12mm, and I used a ratcheting wrench, and gave it several turns.

The other screw, that is hard to reach, didn't seem to do anything. I was hoping it was for a side to side motion, but no such luck. I gave it about one turn, and nothing happened, so I decided not to take a chance and turn it more.

 

[wasteoffilm]

To access the screw near the turn signals, you need to remove the washer fluid tank neck, and possibly the air filter box. I have the K&N setup, and it was difficult to reach.

 

[Anthony]

Excellent information, guys. Thank you.