Intakes back in stock!

[MPFab]

Velocity stacks came back from the powder coater so we are ready to go.
Thanks to all who patiently waited for us to fill back ordered intakes. All back orders went out yesterday.
Thanks again!

 

[cndctrdj]

Do you have more for new orders or was this a backfill

 

[Yosemite Sam]

Your site currently says they are back ordered. Is this still true?

 

[MPFab]

Your site currently says they are back ordered. Is this still true?

No, it's not. I haven't updated it yet. Thanks for the reminder!

I've got 19 or so left after filling orders yesterday.

 

[007CobaltLS]

I'm assuming these won't work on a Cruze turbo (the heat shield portion is what I assume wouldn't work)?

What would it take to get one to work for a Cruze or would you be willing to either make a 1 off for me or start producing for the Cruze community? Of course there would be some R&D involved and I'm not sure if you have access to a Cruze, but if you could make this work I would definitely be in for one.

 

[MPFab]

I'm assuming these won't work on a Cruze turbo (the heat shield portion is what I assume wouldn't work)?

What would it take to get one to work for a Cruze or would you be willing to either make a 1 off for me or start producing for the Cruze community? Of course there would be some R&D involved and I'm not sure if you have access to a Cruze, but if you could make this work I would definitely be in for one.

I'm not against building one for a Cruze, I need to find one locally that I can use for mock up.

 

[007CobaltLS]

I figured that was the biggest issue. I just wasn't sure if there was any other reason. If you do by chance get your hands on a Cruze long enough, I will order one. I don't mind paying extra for the time of your R&D.

 

[007CobaltLS]

Unfortunately, you're too far South for me to consider lending my car. I will be taking road trips in my car, but not that far...at least not yet.