You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Cold side piping discussion
- Thread starter Dragcamaro
- Start date
severous01
New member
bmw popped silicon/rubber pipes all the time. we even had the hard plastic pieces split. and they're only on 7 psi. the sonic is almost 3x this amount. the pope diameter is similar in size as well. maybe 1/2" difference.
i've said it before and i'll say it again...you have many people telling you what's better/best and you're ignoring it. DO WHAT YOU WANT...because you're going to any way.
to the OP, sorry this got way out of hand on a bickering issue. there will be very little performance gain because 20psi is 20psi...and the engine can only consume so much cfm. however, longevity/looks department.....everyone likes shiny n aluminum gets it. however, silicon is cheaper and easier to install. so...again, it's up to you.
i've said it before and i'll say it again...you have many people telling you what's better/best and you're ignoring it. DO WHAT YOU WANT...because you're going to any way.
to the OP, sorry this got way out of hand on a bickering issue. there will be very little performance gain because 20psi is 20psi...and the engine can only consume so much cfm. however, longevity/looks department.....everyone likes shiny n aluminum gets it. however, silicon is cheaper and easier to install. so...again, it's up to you.