hatch back led light kit

[Preloader]

The blinkers blink 3 times and then go into hyperblink mode. I installed the supplied resistors. Maybe I should try adding the 3ohm resistors I bought, that weren't needed to fix the brake light issue.

 

[AndrewGS]

The blinkers blink 3 times and then go into hyperblink mode. I installed the supplied resistors. Maybe I should try adding the 3ohm resistors I bought, that weren't needed to fix the brake light issue.

Replace the supplied resistors. opcorn:

 

[Preloader]

Replace the supplied resistors. opcorn:

No can do. They are sealed inside the assembly now, and ain't nobody got time fa dat.

Could it hurt anything if I just splice in the 3ohm 50w resistors into the line that goes to the supplied ??ohm ??watt resistors and LEDs?

 

[AndrewGS]

It probably won't hurt.

 

[Beastlick]

The blinkers blink 3 times and then go into hyperblink mode. I installed the supplied resistors. Maybe I should try adding the 3ohm resistors I bought, that weren't needed to fix the brake light issue.

exactly what my headlights were doing, I spliced into the stock wiring for the turn and it fixed my issue.

 

[Preloader]

I will try it. I actually like the hyperblink, and would've consider living with it, if the DIC didn't go into freak out mode when it happens.

 

[Eggman]

So what all needs to be done to install these and get them working correctly? I'm a bit confused reading all the suggestions, trial and error.

 

[Preloader]

The kit.
Voltage sensitive relays.
50w resistors.
Tools to cut open taillights.
Basic soldering skills.
Hours of patience.

I didn't have to enthusiasm to take pictures during the project or do a write-up, as this conversion isn't the kind of project I consider fun.

But if anyone wants to tackle it and needs help along the way, I'd be glad to assist.

 

[Eggman]

and where does that 50w resistor go? brake lines?

 

[Preloader]

Inline with the turn signal 12v wire.