LAUNCHED- Forge 1.4T BPV and ATMOSPHERIC BOV **DIRECT FIT**
- Thread starter BNRacing
- Start date
sonic hotness
New member
Sweet thanks
rdss
Junior Member
12 words: I didn't have a small bit to fit in a 1/4" drive.....lol
Damn, for got the lol, 13 words! No, I tried, I dug through all my bit sets hoping to find one, I would have glued that thing into a socket on a 1/4" extension to make it work. With the patience comment, I walked inside a few times, looked at the case of beer and thought "Chris would grab one..... This isn't over, lets wait until you're done to grab one." And then would get a glass of water and start over. The smaller tools would have helped but the biggest problem is getting your dick beaters into the tight space and once you figure that out have the room to actually move to do the job. Honestly, I'm the first to do this and I'm just sharing all my frustrations through the process so that people have the idea of this isn't quick job and that they have an idea of the thought process/tools needed to complete the job and possible make it easier on them. I could have wrote:
1. get a 6" extension (3/8" or preferably 1/4") and T30 bit
2. Pull stock air box/intake/heat shield.
3. Pull vacuum line from factory BPV.
4. Cram hand in from passenger fender side and remove three torx bolts from stock BPV.
4. Install BNR/Forge BOV or BPV replacing with factory torx bolts hand tight plus a little bit more.
5. Reinstall vacuum line.
6. Enjoy your new valve!!
Thaifight-R
Pika Pii!!!
Preloader
The M32 Martyr
Last edited:
turbo
New member
Thanks for the link, but I've been following both of these threads from the beginning, and I'm still not 100% clear on what the differences between the two valves mean.
ThatTmoGuy
New member
one makes more noise than the other...
rdss
Junior Member
No! They are different. The BOV vents to the atmosphere! The BPV recirculates I like the factory valve. The BOV is louder than the stock BPV by far but isn't to loud under normal loads. When I get back in town I'm going to put a few miles on the BOV and then will swap in the BPV from BNR and give a review on it. Install will be identical and maybe slightly easier since it isn't as tall as the BOV.
sonic hotness
New member
wonder how much louder the bpv is over stock
ThatTmoGuy
New member
I was trying to K.I.S.S. (keep it simple stupid) as this has been explained in the other thread many times...
ThatTmoGuy
New member
with NLS there will be no difference besides noise.
